Memory Information?

[turboManiac]

SMBUS read&write byte is for memory information but does anybody knows if this works?

[Muetze1]

Zitat von turboManiac:

SMBUS read&write byte is for memory information ...

Not only memory information. The SM-Bus is also used by the temperature and fan controlling hardware and many other (even cards) using the SM-Bus interface. The 3Com 3c905 full configurable networking card offers a SM-Bus interface connector and can be connected to the mainboard. So you can also access the network card and gathering information about it through the SM-Bus.

And how it works? The SM-Bus is completly documented because it is a hardware standard.

[Razor]

@Muetze1:But where to get ports for example nforce motherboards?Basicly datasheets?But i think nforce info is gathered via PCI.

[Muetze1]

Zitat von Razor:

@Muetze1:But where to get ports for example nforce motherboards?Basicly datasheets?But i think nforce info is gathered via PCI.

We discussed all before and all needed thinks are said...

But for you once again: mostly all chipsets implement a SMBus controller PCI device. The device PCI register contains the port address of the SMBus interface. The ports are mostly a little bit vendor specific.

Look for a PCI device with class id 0x0c and sub class id 0x05.

[Razor]

Thank you i will post my results after i make it.

[Razor]

But i think i found an easier way

Delphi-Quellcode:

procedure TMainFrm.Button3Click(Sender: TObject);
begin

MiTeC_Machine1.SMBIOS.RefreshData;;

mainfrm.Caption:=inttostr(MiTeC_Machine1.SMBIOS.MemoryModule[1].Size);
end;

The caption is 0 after i press it size is cardinal

[KyleKatarn]

Hi !

I need to access SDP from my Delphi 7 free application... where can i find the complete memory.pas module that have been discussed here ?

Thanks !!

[jaenicke]

What about the one a few post above yours?
http://www.delphipraxis.net/96808-me...tml#post660360

[KyleKatarn]

Thank you !

Same error as EarthQuaker :

Zitat:

[Fehler] Memory.pas(67): Undefinierter Bezeichner: 'GetInstance'
[Fehler] Memory.pas(67): Operator oder Semikolon fehlt
[Fehler] Memory.pas(77): Operator oder Semikolon fehlt
[Fehler] Memory.pas(95): Undefinierter Bezeichner: 'GetInstance'
[Fehler] Memory.pas(95): Operator oder Semikolon fehlt
[Fehler] Memory.pas(96): Operator oder Semikolon fehlt
[Fehler] Memory.pas(97): Operator oder Semikolon fehlt
[Fehler] Memory.pas(98): Operator oder Semikolon fehlt
[Fehler] Memory.pas(99): Operator oder Semikolon fehlt
[Fehler] Memory.pas(100): Operator oder Semikolon fehlt
[Fehler] Memory.pas(132): Undefinierter Bezeichner: 'GetInstance'
[Fehler] Memory.pas(132): Operator oder Semikolon fehlt
[Fehler] Memory.pas(154): Undefinierter Bezeichner: 'GetInstance'
[Fehler] Memory.pas(154): Operator oder Semikolon fehlt
[Fehler] Memory.pas(155): Operator oder Semikolon fehlt
[Fehler] Memory.pas(188): Undefinierter Bezeichner: 'GetInstance'
[Fehler] Memory.pas(188): Operator oder Semikolon fehlt
[Fehler] Memory.pas(189): Operator oder Semikolon fehlt
[Fehler] Memory.pas(213): Undefinierter Bezeichner: 'GetInstance
...

What should i do ? am i missing something ? (dependencies,....)

[Horst0815]

add uses OMCDrv;